Skip to content
Fault code dictionary (DTC)

P04C5 — Fuel door lock position sensor: circuit low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit saw a lower than normal voltage on the fuel door lock position sensor circuit. Usually the wire touches ground or is broken, or the sensor is faulty.
FamilyPowertrain (P)

Typical symptoms

Check engine or warning light on
Warning that the door is not locked, or locked wrongly
Lock works but gives no confirmation on the dashboard
Door does not respond to commands
Fault message on the dashboard

Common causes

Sensor wire touching ground
Wet or corroded connector
Faulty sensor or microswitch
Broken sensor supply wire
Control unit with a damaged input

What to do

Check the lock connector and look for moisture or damaged wires towards the fuel door. You can drive, but have it checked reasonably soon.

How to read code P04C5

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P04C5 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (C5) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P04C5 mean?

Fuel door lock position sensor: circuit low. The control unit saw a lower than normal voltage on the fuel door lock position sensor circuit. Usually the wire touches ground or is broken, or the sensor is faulty.

Can I keep driving with code P04C5 active?

With caution: limp mode possible, have it checked soon

Common causes — P04C5

Sensor wire touching ground Wet or corroded connector Faulty sensor or microswitch Broken sensor supply wire Control unit with a damaged input

How do you fix code P04C5?

Check the lock connector and look for moisture or damaged wires towards the fuel door. You can drive, but have it checked reasonably soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes