Skip to content
Fault code dictionary (DTC)

P04CA — Fuel door open request switch: circuit low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit saw a lower than normal voltage on the fuel door open request switch circuit. Usually the wire touches ground, or the switch is shorted.
FamilyPowertrain (P)

Typical symptoms

Check engine or warning light on
Door does not open, or opens by itself
Button does not respond
Fault message on the dashboard
Emergency release needed to refuel

Common causes

Button wire touching ground
Wet or corroded connector
Switch or sensor shorted
Circuit supply interrupted
Control unit with a damaged input

What to do

Look for moisture, damaged wires or corroded connectors near the button and the fuel door. It does not stop you driving, but have it checked reasonably soon.

How to read code P04CA

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P04CA starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (CA) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P04CA mean?

Fuel door open request switch: circuit low. The control unit saw a lower than normal voltage on the fuel door open request switch circuit. Usually the wire touches ground, or the switch is shorted.

Can I keep driving with code P04CA active?

With caution: limp mode possible, have it checked soon

Common causes — P04CA

Button wire touching ground Wet or corroded connector Switch or sensor shorted Circuit supply interrupted Control unit with a damaged input

How do you fix code P04CA?

Look for moisture, damaged wires or corroded connectors near the button and the fuel door. It does not stop you driving, but have it checked reasonably soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes