Skip to content
Fault code dictionary (DTC)

P04CB — Fuel door open request switch: circuit high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit saw a higher than normal voltage on the fuel door open request switch circuit. There may be a short to a positive supply, a broken wire or a faulty switch.
FamilyPowertrain (P)

Typical symptoms

Check engine or warning light on
Door does not respond to the button
Door tries to open without a request
Button seems not to work
Fault message on the dashboard

Common causes

Button wire touching a positive supply
Broken wire leaving the signal floating
Connector with corroded or loose terminals
Faulty switch or sensor
Control unit with a faulty input

What to do

Check the button connector and wiring for bare wires or corroded terminals. It will not stop the car, but have it checked soon.

How to read code P04CB

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P04CB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (CB) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P04CB mean?

Fuel door open request switch: circuit high. The control unit saw a higher than normal voltage on the fuel door open request switch circuit. There may be a short to a positive supply, a broken wire or a faulty switch.

Can I keep driving with code P04CB active?

With caution: limp mode possible, have it checked soon

Common causes — P04CB

Button wire touching a positive supply Broken wire leaving the signal floating Connector with corroded or loose terminals Faulty switch or sensor Control unit with a faulty input

How do you fix code P04CB?

Check the button connector and wiring for bare wires or corroded terminals. It will not stop the car, but have it checked soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes