P04D0 — EGR temperature sensor C: low signal
| Meaning | The control unit sees a voltage that is too low on the circuit of EGR temperature sensor "C", as if the sensor were shorted to ground or reporting an impossible temperature. This usually points to an electrical problem rather than a problem with the recirculated gas. The exact meaning of the letter "C" varies by manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Irregular running when cold
Slight loss of performance
Possible power limitation
Exhaust smoke under some conditions
Common causes
Wiring with insulation damaged by heat or rubbing
Internally faulty EGR temperature sensor
Water or corrosion in the connector
Faulty engine control unit (rare)
What to do
How to read code P04D0
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P04D0 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (D0) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P04D0 mean?
EGR temperature sensor C: low signal. The control unit sees a voltage that is too low on the circuit of EGR temperature sensor "C", as if the sensor were shorted to ground or reporting an impossible temperature. This usually points to an electrical problem rather than a problem with the recirculated gas. The exact meaning of the letter "C" varies by manufacturer.
Can I keep driving with code P04D0 active?
With caution: limp mode possible, have it checked soon
Common causes — P04D0
Signal wire shorted to ground Wiring with insulation damaged by heat or rubbing Internally faulty EGR temperature sensor Water or corrosion in the connector Faulty engine control unit (rare)
How do you fix code P04D0?
Inspect the wiring and connector along their whole length, especially where the wire passes near hot parts or sharp edges. Drive carefully and have it checked soon, because the control unit is working with unreliable data.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P04CF — EGR temperature sensor C: signal out of range
- Next code: P04D1 — EGR temperature sensor C: high signal
Related codes
- P0400 — Exhaust Gas Recirculation Flow Malfunction
- P0401 — EGR: insufficient recirculation flow
- P0402 — EGR: excessive recirculation flow
- P0403 — EGR control circuit
- P0404 — EGR: control circuit range/performance
- P0405 — EGR sensor A circuit low
- P0406 — EGR sensor A circuit high
- P0407 — EGR sensor B circuit low
- P0408 — EGR sensor B circuit high
- P0409 — Exhaust Gas Recirculation Sensor A Circuit
- P040A — EGR temperature sensor A circuit fault
- P040B — EGR temperature sensor 1 circuit performance