P04D1 — EGR temperature sensor C: high signal
| Meaning | The control unit sees a voltage that is too high on the circuit of EGR temperature sensor "C", as if the circuit were open or shorted to the supply voltage. The signal cannot be used and EGR control suffers as a result. The letter "C" depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Irregular idle
Loss of performance
Possible limp mode
Higher than normal emissions
Common causes
Broken signal wire
Faulty EGR temperature sensor
Wire shorted to the supply voltage
Faulty engine control unit (rare)
What to do
How to read code P04D1
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P04D1 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (D1) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P04D1 mean?
EGR temperature sensor C: high signal. The control unit sees a voltage that is too high on the circuit of EGR temperature sensor "C", as if the circuit were open or shorted to the supply voltage. The signal cannot be used and EGR control suffers as a result. The letter "C" depends on the manufacturer.
Can I keep driving with code P04D1 active?
With caution: limp mode possible, have it checked soon
Common causes — P04D1
Connector unplugged or with corroded contacts Broken signal wire Faulty EGR temperature sensor Wire shorted to the supply voltage Faulty engine control unit (rare)
How do you fix code P04D1?
Start with the sensor connector: check that it is fully seated and free of corrosion, then check that the wires are not broken. Don't ignore this for long, because the EGR system is running without proper control.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P04D0 — EGR temperature sensor C: low signal
- Next code: P04D2 — EGR temperature sensor C: intermittent signal
Related codes
- P0400 — Exhaust Gas Recirculation Flow Malfunction
- P0401 — EGR: insufficient recirculation flow
- P0402 — EGR: excessive recirculation flow
- P0403 — EGR control circuit
- P0404 — EGR: control circuit range/performance
- P0405 — EGR sensor A circuit low
- P0406 — EGR sensor A circuit high
- P0407 — EGR sensor B circuit low
- P0408 — EGR sensor B circuit high
- P0409 — Exhaust Gas Recirculation Sensor A Circuit
- P040A — EGR temperature sensor A circuit fault
- P040B — EGR temperature sensor 1 circuit performance