Skip to content
Fault code dictionary (DTC)

P04D5 — Exhaust brake input: low signal

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit sees a voltage that is too low in the exhaust brake input circuit, as if the wire were grounded or the command were always on. It is generally an electrical problem. The details depend on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Engine brake not responding to the command
Engine brake always on or engaging by itself
Engine seeming to brake abnormally
Warning on the dashboard on some models

Common causes

Signal wire shorted to ground
Control switch stuck or damaged
Wiring damaged by heat or rubbing
Water or corrosion in the connector
Faulty control unit (rare)

What to do

Look for pinched or burnt wires and check the control switch. If the engine brakes by itself or in a strange way, have it checked right away: it can affect how safely you can drive.

How to read code P04D5

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P04D5 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (D5) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P04D5 mean?

Exhaust brake input: low signal. The control unit sees a voltage that is too low in the exhaust brake input circuit, as if the wire were grounded or the command were always on. It is generally an electrical problem. The details depend on the manufacturer.

Can I keep driving with code P04D5 active?

With caution: limp mode possible, have it checked soon

Common causes — P04D5

Signal wire shorted to ground Control switch stuck or damaged Wiring damaged by heat or rubbing Water or corrosion in the connector Faulty control unit (rare)

How do you fix code P04D5?

Look for pinched or burnt wires and check the control switch. If the engine brakes by itself or in a strange way, have it checked right away: it can affect how safely you can drive.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes