Skip to content
Fault code dictionary (DTC)

P04D6 — Exhaust brake input: high signal

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit sees a voltage that is too high in the exhaust brake input circuit, as if the circuit were open or shorted to the supply voltage. The command is not being read reliably. The details depend on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Engine brake not working
Engine brake command having no effect
More effort needed to slow down on descents
Warning on the dashboard on some models

Common causes

Connector unplugged or corroded
Broken signal wire
Faulty control switch
Short to the supply voltage
Faulty control unit (rare)

What to do

Check that the switch connector is fully seated and that the wires are intact. In the meantime do not count on the engine brake and use the service brakes carefully.

How to read code P04D6

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P04D6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (D6) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P04D6 mean?

Exhaust brake input: high signal. The control unit sees a voltage that is too high in the exhaust brake input circuit, as if the circuit were open or shorted to the supply voltage. The command is not being read reliably. The details depend on the manufacturer.

Can I keep driving with code P04D6 active?

With caution: limp mode possible, have it checked soon

Common causes — P04D6

Connector unplugged or corroded Broken signal wire Faulty control switch Short to the supply voltage Faulty control unit (rare)

How do you fix code P04D6?

Check that the switch connector is fully seated and that the wires are intact. In the meantime do not count on the engine brake and use the service brakes carefully.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes