P04E7 — EGR temperature sensor D: circuit signal too low
| Meaning | The engine computer sees a lower than normal voltage on the circuit of EGR temperature sensor "D". This usually points to a short to ground or an internal sensor failure. Sensor "D" is defined by the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle
Loss of performance
Reduced-power mode
No obvious symptoms
Common causes
Wet or corroded connector
Faulty EGR temperature sensor
Wiring crushed or burned near the exhaust
Engine computer fault (rare)
What to do
How to read code P04E7
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P04E7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (E7) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P04E7 mean?
EGR temperature sensor D: circuit signal too low. The engine computer sees a lower than normal voltage on the circuit of EGR temperature sensor "D". This usually points to a short to ground or an internal sensor failure. Sensor "D" is defined by the manufacturer.
Can I keep driving with code P04E7 active?
With caution: limp mode possible, have it checked soon
Common causes — P04E7
Sensor wire shorted to ground Wet or corroded connector Faulty EGR temperature sensor Wiring crushed or burned near the exhaust Engine computer fault (rare)
How do you fix code P04E7?
Inspect the wiring along its route to the sensor, especially near hot parts, and the connector. If the car goes into limp mode, avoid heavy loads and have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P04E6 — EGR temperature sensor D: reading out of range
- Next code: P04E8 — EGR temperature sensor D: circuit signal too high
Related codes
- P0400 — Exhaust Gas Recirculation Flow Malfunction
- P0401 — EGR: insufficient recirculation flow
- P0402 — EGR: excessive recirculation flow
- P0403 — EGR control circuit
- P0404 — EGR: control circuit range/performance
- P0405 — EGR sensor A circuit low
- P0406 — EGR sensor A circuit high
- P0407 — EGR sensor B circuit low
- P0408 — EGR sensor B circuit high
- P0409 — Exhaust Gas Recirculation Sensor A Circuit
- P040A — EGR temperature sensor A circuit fault
- P040B — EGR temperature sensor 1 circuit performance