P04E8 — EGR temperature sensor D: circuit signal too high
| Meaning | The engine computer sees a higher than normal voltage on the circuit of EGR temperature sensor "D". This usually means a broken wire, an unplugged connector or a failed sensor. Sensor "D" is defined by the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Unstable idle
Power loss
Possible engine protection mode
No obvious symptoms
Common causes
Corroded terminals in the connector
Faulty EGR temperature sensor
Wiring damaged by heat
Short to supply voltage
Engine computer fault (rare)
What to do
How to read code P04E8
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P04E8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (E8) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P04E8 mean?
EGR temperature sensor D: circuit signal too high. The engine computer sees a higher than normal voltage on the circuit of EGR temperature sensor "D". This usually means a broken wire, an unplugged connector or a failed sensor. Sensor "D" is defined by the manufacturer.
Can I keep driving with code P04E8 active?
With caution: limp mode possible, have it checked soon
Common causes — P04E8
Broken wire or unplugged connector Corroded terminals in the connector Faulty EGR temperature sensor Wiring damaged by heat Short to supply voltage Engine computer fault (rare)
How do you fix code P04E8?
Check that the connector is fully seated and the terminals are clean, then check the wire all the way to the sensor. With a failed sensor, EGR control may be reduced, so don't put it off.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P04E7 — EGR temperature sensor D: circuit signal too low
- Next code: P04E9 — EGR temperature sensor D: erratic or intermittent...
Related codes
- P0400 — Exhaust Gas Recirculation Flow Malfunction
- P0401 — EGR: insufficient recirculation flow
- P0402 — EGR: excessive recirculation flow
- P0403 — EGR control circuit
- P0404 — EGR: control circuit range/performance
- P0405 — EGR sensor A circuit low
- P0406 — EGR sensor A circuit high
- P0407 — EGR sensor B circuit low
- P0408 — EGR sensor B circuit high
- P0409 — Exhaust Gas Recirculation Sensor A Circuit
- P040A — EGR temperature sensor A circuit fault
- P040B — EGR temperature sensor 1 circuit performance